Cleveland KGL-T Reparaturanleitung

INSTALLATION, OPERATION AND REPAIR MANUAL GAS KETTLE MODEL # KGL KGL-T CLEVELAND RANGE INC.

PARTS LIST - GAS CONTROL ASSEMBLY ( KETTLE ) ITEM NO. PART NO. DESCRIPTION QTY. 1. KE53402 Air orifice, 140K BTU burner 1 KE53402-1 Air orif

GAS CONTROL ASSEMBLY ( KETTLE )

PARTS LIST - SIDE BOX ASSEMBLY (KETTLE) ITEM NO. PART NO. DESCRIPTION QTY. 1. N/A Sight glass 1 2. KE53437 Igniter 1 3. KE01432 Enclosure

SIDE BOX ASSEMBLY ( KETTLE )

PARTS LIST - 2" TANGENT DRAW-OFF VALVE ITEM NO. PART NO. DESCRIPTION QTY. 1. to 7. KE50972-B Draw-off assembly 1 KE509721 Draw-off assembly, fo

PARTS LIST - HINGE ASSEMBLY ITEM NO. PART NO. DESCRIPTION QTY. 1. - 9. KE00598 Hinge assembly (40 gal. and under) 1 SK00168 Hinge assembly (6

IMPORTANT THE FOLLOWING POINTS ARE TO INSURE THE SAFE INSTALLATION AND OPERATION OF THIS EQUIPMENT : INSURE ALL GAS AND ELECTRICAL SUPPLIES MATCH RAT

FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE LIQUIDS AND VAPOURS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. GENERAL

3. Arrange for the carrier's representative to examine the damage. 4. Fill out all carrier claims forms and have the examining carrier

OPERATION 1. Before turning the kettle on, read the vacuum/pressure gauge. The gauge's needle should be in the green zone. If the needle is

4. Open the draw-off valve to drain the wash water. 5. The draw-off valve should be cleaned as follows: a. Remove the drain screen from

In order to preserve the various agency safety certification (UL, A.G.A., CSA. CGA, NSF, ASME/Ntl. Bd., etc.), only factory-supplied replacement parts

PARTS LIST - ELECTRICAL COMPONENT BOX ASSEMBLY ITEM NO. PART NO. DESCRIPTION QTY. 1. KE51141 Transformer, 120-16V. 1 2. KE52690 Bushing 1 3.

PARTS LIST - PRESSURE RELIEF ASSEMBLY ITEM-NO. PART NO. DESCRIPTION QTY. 1. FI05215 Cap, 1/2" 1 2. FI05225 Nipple, 1/2" 1 3. FI00