Cleveland CR-32 Bedienungsanleitung

131613231517226141912181244168 - TERMINAL BLOCK, 2 POLEWR50037 - MOTOR CONTROLLERWR50191 - TIMER, 1.5 SECOND DELAY106175 - TERMINAL BLOCK, 4 POLE, W/J

CLEVELAND RANGE SEQUENCE OF OPERATIONSCR-32 Rotisserie(NCC Control)When using these instructions refer to the CR-32 wiring schematic.1. To turn the u

• Ignition module sends 24 VAC to the main (low) coil of the gas valve and gas(2.2” W.C. natural gas, 4.0” W.C. L.P) is sent to the infrared burner.•

• Ignition module sends 24 VAC through the fan prover switch to the pilot coil andgas is sent to the pilot.• Ignition module sends 24 VAC to the mai

108592 F ROTISSERIE, NCC CONTROL, 120V, 60HZON RELAY / MOTOR BOARDDENOTES PINS ATTACHED TO J3 QUICK - CONNECT ON RELAY MOTOR BOARD.DENOTES PINS ATTA

CLEVELAND RANGE SEQUENCE OF OPERATIONSBMR Rotisserie(FAST Control)When using these instructions refer to the BMR wiring schematic.1. To turn the unit

• The motor turns the drive system at 3 RPM.• The K1 relay on the RIB closes sending 24 VAC from terminal T3 on the RIB throughthe fan prover switch

• At least .5 micro amps D.C. is received at the module in 4 seconds or the ignitionmodule locks out and the alarm buzzer sounds.• If the burner set

T26MOTOR1 SEC. DELAY3PRIMARY+ BLUESECONDARYTRANSFORMER115VTHERMISTERT°24VJOGSWITCHJ1J212132R1T31T32T34POWERDOORSWITCHIGNITIONMODULECONTROLCOMMUNICATIO